# techmannih - Screenshot2026-10-29at10.01.40.png

Channel: #contributor
Source: https://discord.com/channels/1233487248129921135/1565222735821414480
Started: 2026-10-29T04:36:21.388000+00:00
Last activity: 2026-10-29T04:40:01.534000+00:00

## techmannih — 2026-10-29T04:39:41.143000+00:00

This is a JLCPCB-imported USB-C connector. When I download the KiCad Project ZIP from tscircuit.com and run DRC in KiCad, I get hole-clearance errors because the clearance between the holes and SMD pads is only **0.1451 mm**, while KiCad requires a minimum of **0.20 mm**.

What should we do in this case?
Attachment: Screenshot_2026-10-29_at_10-08-37.png — https://community.tscircuit.com/media/1565223576389288048

## techmannih — 2026-10-29T04:40:01.534000+00:00

<@757706909351411845> <@809856037376491570>