# https://tscircuit.com/rushabhcodes/

Channel: #designreview
Source: https://discord.com/channels/1233487248129921135/1562508828400951358
Started: 2026-10-21T17:28:02.850000+00:00
Last activity: 2026-10-21T18:09:32.185000+00:00

## ! Rushabh | Linux Shill — 2026-10-21T16:52:14.701000+00:00

https://tscircuit.com/rushabhcodes/fidget-counter#3d <@778624824875941908>

## Seve — 2026-10-21T17:28:04.330000+00:00

we don't program with test pads, you need to add a tscircuit.com/tscircuit/standard-jst-programmer JST connector

## Seve — 2026-10-21T17:28:09.254000+00:00

probably the 5 pin connector

## Seve — 2026-10-21T17:28:23.835000+00:00

this has 3d going through the pcb, you need to use a bolt
Attachment: CleanShot_2026-10-21_at_10.27.142x.png — https://community.tscircuit.com/media/1562517925980536932

## ! Rushabh | Linux Shill — 2026-10-21T18:05:39.064000+00:00

yeah but i wanted to minimize the height of the board

## ! Rushabh | Linux Shill — 2026-10-21T18:05:44.570000+00:00

we'll add that now

## Seve — 2026-10-21T18:09:32.185000+00:00

you can use the horizontal jsts which are lower, if you really want to use test pads, you have to use a special standard which the programmer supports, look the bottom test pad connector https://tscircuit--standard-jst-programmer-v0-8-0.tscircuit.app/#file=circuits%2Fupward.circuit.tsx
Attachment: CleanShot_2026-10-21_at_11.08.592x.png — https://community.tscircuit.com/media/1562528279209181184
Attachment: CleanShot_2026-10-21_at_11.09.222x.png — https://community.tscircuit.com/media/1562528279490203758