# Seve - Linux is running!!! https://x.com/seveib... Channel: #contributor Source: https://discord.com/channels/1233487248129921135/1554648905776373820 Started: 2026-09-30T00:19:43.424000+00:00 Last activity: 2026-09-30T12:49:48.022000+00:00 ## Seve — 2026-09-30T00:19:43.117000+00:00 Linux is running!!! https://x.com/seveibar/status/2105089653795873274?s=20 We now have a way to run linux, Huzzah! https://tscircuit.com/seveibar/f1c1990s-dev-board ## 0hmx — 2026-09-30T05:19:38.218000+00:00 Wow ## Seve — 2026-09-30T05:20:07.397000+00:00 NOTE: package was renamed https://tscircuit.com/seveibar/f1c100s-linux-dev-board#files ## 0hmx — 2026-09-30T05:20:43.916000+00:00 this is crazyyy ## 0hmx — 2026-09-30T05:20:55.210000+00:00 only dram is left ig ## Seve — 2026-09-30T05:21:15.360000+00:00 and we're not too far from that!!! https://tscircuit.com/seveibar/am3352-ram-dogbone-and-single-layer-route-test#pcb ## 0hmx — 2026-09-30T05:21:36.530000+00:00 how did it get that clean ## Seve — 2026-09-30T05:21:36.786000+00:00 but yea DRAM is really the last major thing imo ## Seve — 2026-09-30T05:22:00.848000+00:00 it is an algo, you can read my chat, i told it to optimize to reduce certain things that i specified ## Seve — 2026-09-30T05:22:36.590000+00:00 https://chatgpt.com/s/cx_6abc9c9362cc8191a3faf506eae865b2 < start from the top (I'd recommend) ## shibo — 2026-09-30T05:50:22.552000+00:00 <@757706909351411845> what was the exact issue with the pcb? did you swap the regulator in your tscircuit.com package or not? also how well did linux run? ## Seve — 2026-09-30T05:51:50.595000+00:00 the package is fixed now, i didn't do a performance test and will try to plug in a SPI screen tomorrow and run something that can sort of show us the speed of the thing (although it is a PITA with the variable power supply) i replaced one of the 3 regulators with a variable power supply to provide the correct voltage linux ran totally fine, it is a linux command line so not much to it until we install python or something 😁 ## 0hmx — 2026-09-30T12:49:48.022000+00:00 I got sabotaged by 6.1 Sol. It spent the whole morning basically doing the same thing while trying to route a Pico 2W using the AM3352, and it made absolutely zero progress. It had no idea what was going on. What makes even less sense is that I used Sol 6 to route the same board, the same chip, and the same RAM before. AHHHH